That said, you may need to trim out the back 'slot' on the element tokens a little in order for them to seat properly with the alignment peg in the frames, the tolerances there are a bit snug.

Those who suffer from bad stringing will need to remove any strings and seams before slotting the pieces in. I printed all the air temples in one go as well as the southern and northern water tribes.įor the most part, these pieces should not need to be cleaned up to fit. The landmasses all took 10-20 minutes each, except for the Earth Kingdom which took 1 hour and 38 minutes. 4mm nozzle, so excellent bed adhesion is imperative.įrames- Hatchbox Wood Medium and DO3D Silk Coffee Goldįire- Spidermaker PLA+ Matte Jujube Red (Currently Unavailable)Īir- Spidermaker PLA+ Matte Concrete Gray (Currently Unavailable) There are lots of extremely tiny islands that are about as small as you can print with a. 4mm.Ī little bit of 'elephant's foot' on your prints won't cause any issues, but too much will cause the pieces not to fit, so be aware of that. That said, the result shown above was done with. For absolutely best results, both the landmasses and characters should be printed with a. 38mm line width in order to fully capture them. You may need to print the written characters with. 12mm layer height or lower because the details in the waves are too fine to be captured well at larger resolutions. 2mm resolution, the steps will likely be uneven. 15mm exactly, as the 'steps' are tiered in multiples of. 2mm layer height, colors will need to be swapped at the following heights:įor the best results, the landmasses and the ocean should be printed at specific layer heights. If you want the accent colors on the frames and the black text on the tokens, you'll need to do some layer swaps. The split models stagger the islands such that this isn't an issue.įor me, this was an extremely fun and rewarding build! I highly recommend it. For example, the very last island on the Fire Nation island chain will be indistinguishable from the stringing that connects it to its closest neighbor, causing a bit of headache during cleanup. Some of the islands are so small that it's even difficult to tell where to trim. In such cases, even the smallest amount of stringing will cause them to attach in an inconvenient way. stl models?'Ī: Well, there are some very tiny islands that are very close to other very tiny islands.

This is also at a much higher resolution than other available maps, including finder detail regarding both landmass coastline and topology layers. This map has features that are not included on other maps- You'll be able to find Kyoshi's Island, the Boiling Rock, Roku's Island, and the magnetic center of the Si Wong desert. In this model, the landmasses print like puzzle pieces that fit into the background- it's done this way to make it as easy as possible to have multiple colors. This is a 3D topographic map of the Avatar: The Last Airbender world.

Avatar world map last airbender